Kitchen Island Installation in Palm Springs, CA

Palm Springs Kitchen Remodeling Pros is the Coachella Valley's trusted expert in kitchen island installation, specializing in custom island cabinetry, quartz and granite island tops, and mitered waterfall edge fabrication. We run dedicated island circuits and prep sink plumbing.

Our team builds seating overhangs with concealed steel support, creating durable, everyday work surfaces for homes and clean, inspection-ready installations on every project. Backed by $5 million in general liability insurance, we've completed projects from a simple 4-foot prep block to a 10-foot island with a second sink, a downdraft and four seats.

From saw-cutting a slab-on-grade floor to bring a drain and a gas line to the center of the room, to seam layout on a 3cm quartz top, our team handles every detail. Serving Palm Springs, Cathedral City, Palm Desert and Indian Wells, we hold a firm schedule and deliver solid, well-supported, genuinely usable results on every kitchen island project.

Call (442) 212-1511 for a free in-home estimate. We measure your clearances first, because an island that does not fit the room is a very expensive mistake.

What We Build Into an Island

The Cabinet Base

Framed or frameless boxes, built to the island's real dimensions rather than assembled from leftovers. Base cabinets run 24 inches deep and 34.5 inches high as standard, in widths from 9 to 45 inches in 3-inch increments, and an island usually combines several. Back panels get finished, because on an island every side is a visible side.

• Deep pot and pan drawers on full-extension slides
• Soft-close hinges throughout
• Trash and recycling pull-outs
• Blind corner pull-outs and mixer shelves that spring to counter height
• Bookcase or open shelving on the seating end

Power, Plumbing and Ventilation

• Electrical. At least one dedicated island circuit with GFCI protection, plus outlets placed to code. Pop-up and under-lip outlets keep a slab face clean.
• Prep sink. A second smaller bowl with its own faucet and disposal. Sink installation alone typically runs $330 to $1,300 and a faucet $200 to $600.
• Gas. For a cooktop in the island, which also brings ventilation into the conversation.
• Ventilation. An island cooktop needs an island or ceiling-mount hood sized in CFM, or a downdraft. High-CFM ducted hoods need makeup air in a tightly sealed house, so we check that rather than assume it.
• Lighting. Pendants over the island and recessed cans around it. Six recessed fixtures typically run $700 to $1,650 installed.

The Countertop

Quartz, granite, quartzite, porcelain, butcher block or stainless. Islands are where people spend on material because it is the surface everyone looks at. A mitered waterfall edge, where the top turns down the sides in a continuous grain, adds slab and fabrication labor to the number.

Clearances: Will an Island Actually Fit

This is the question we answer first, before anyone talks about door styles.

An overhang past about 12 inches on stone needs concealed steel brackets or a support panel. We spec that at design rather than discovering it at install.

Kitchen Island Cost in Palm Springs

What moves the number:

• Whether utilities go to the middle of the room. In a slab-on-grade house, a prep sink means saw-cutting concrete, trenching the drain, repouring and patching the floor. That single decision is often the largest line on the estimate.
• Countertop material. Granite installs at $40 to $100 per square foot, quartz at $60 to $150, quartzite at $80 to $250. An island top is a large, mostly uninterrupted piece, so material choice compounds.
• Waterfall panels. Two extra slab faces plus a mitered joint on each side.
• Ventilation. A ceiling-mount hood over an island means running duct through the ceiling, which is a different job in a post-and-beam roof than in a house with an attic.
• Electrical capacity. An older panel may not carry a new circuit plus an induction cooktop.
• Permits. City of Palm Springs permits run roughly $500 to $1,500 when plumbing, gas or electrical work is involved.

Islands in Mid-Century Palm Springs Floor Plans

Most of the houses we work in were not designed around an island. The Twin Palms tract, built in 1957 and 1958 to William Krisel's post-and-beam plans, runs about 1,600 square feet with butterfly rooflines and a compact kitchen. The Alexander Construction Company built roughly 2,200 homes here between 1947 and 1965 on similar logic: closed galleys, 8-foot ceilings, everything against a wall.

Two things follow from that. First, an island usually arrives with a wall coming out, which is a structural job with a beam and a permit, and it is worth reading our open concept kitchen remodeling in Palm Springs before you commit to a footprint. Second, the ceiling is often the best feature in the house, which rules out a big ducted ceiling hood and points toward a downdraft or a slim island hood that does not compete with the beams.

Slab-on-grade construction is the other constant. Almost every post-war house here sits on a slab, so plumbing and gas to a free-standing island get cut into concrete rather than dropped through a joist bay. We tell you at the estimate whether your island needs a saw cut, because that is where a cheerful $5,000 island becomes a $12,000 one and homeowners deserve to hear it in week zero, not week three.

Why Homeowners Hire Us for Islands

• Licensed and insured. $5 million in general liability. Certificate on request before work starts.
• Clearances checked before anything is ordered. We tape the footprint on your floor and walk it with you.
• Slab work done properly. Saw cut, trench, plumb, inspect, repour and patch so the finished floor reads flat.
• Overhang support engineered, not guessed. Steel brackets or panel support, concealed.
• Absentee-owner workflow. Lockbox access, dated photo updates, written email approvals.